Repair Work; Repair Personnel; Repair Notes; Tools - WAGNER GM 4700AC Original Operating Manual

VERSION 06/2018

10 REPAIR WORK

10.1 REPAIR PERSONNEL

Repair work should be undertaken carefully by qualified and trained personnel. They
should be informed of specific hazards during their training.
The following hazards may arise during repair work:
– risk to health from inhaling solvent vapors,
– use of unsuitable tools and aids.
A skilled person must check to ensure that the device is in a reliable state after it is repaired.
Carry out function test in accordance with Chapter 11.

10.2 REPAIR NOTES

DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Use only WAGNER original spare parts and accessories.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
- Relieve the pressure from the spray gun, high-pressure hoses and all devices.
- Secure the spray gun against actuation.
- Switch off the energy and compressed air supply.
- Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
Before Repair Work
– Flush and clean the system in accordance with Chapter 8.1.2.
− Interrupt the air supply.
After Repair Work
– Carry out safety checks in accordance with Chapter 8.2.3.
– Put the system into operation and check for leaks as described in Chapter 6.8.
− Have the system checked for safe condition by an authorized person.
– Function test in accordance with Chapter 11.

10.3 TOOLS

The following tools are required for carrying out the repair work on the gun described
below:
- Open-end wrench, SW 5
- Open-end wrench, SW 6
- Open-end wrench, SW 7
- Open-end wrench, SW 13
- Open-end wrench, SW 15
- Socket wrench, size 13
ORDER NUMBER DOC2311730
- Socket wrench, size 15
- Mounting key, Order no. 179989
- Nozzle wrench, complete, Order no. 128901
- Torque wrench 12±1 Nm; 8.85 lbft
- Pipe wrench
- Pin 1.5 mm
33