Appendices; Appendix 1 Example Applications Of The Fb Library - Mitsubishi Electric MELSEC iQ-F Series Quick Connection Manual

APPENDICES

Appendix 1
The following table lists the FBs included in the FB library for CC-Link IE Field Network Basic compatible inverters. Programs
are created by combining FBs according to each application.
This section provides the example programs for the station number 1.
List of FBs for CC-Link IE Field Network Basic compatible inverters
Name
M+INVERTER-CC-IEF-Basic_Running
M+INVERTER-CC-IEF-Basic_ResetError
M+INVERTER-CC-IEF-Basic_StopRunning
M+INVERTER-CC-IEF-Basic_WriteFRQ_TRQ
M+INVERTER-CC-IEF-Basic_ExecuteCommandCode
M+INVERTER-CC-IEF-Basic_SetParameter
M+INVERTER-CC-IEF-Basic_MonitorStatus
M+INVERTER-CC-IEF-Basic_MonitorFRQ
M+INVERTER-CC-IEF-Basic_MonitorAlarm
M+INVERTER-CC-IEF-Basic_ReadParameter
Example programs using FBs
Example program
Sending the operation command to the inverter and
changing and monitoring a frequency of the inverter
Changing and checking the parameter
Switching the operation mode
Resetting an inverter error
APPX
47

Appendix 1 Example Applications of the FB Library

Example Applications of the FB Library
Description
Outputs inverter operation control commands to operate inverters.
Resets fault of the inverter with the specified station number.
Stops output of the inverter with the specified station number. (The output is stopped by turning ON
the MRS signal.)
Writes the frequency/torque command value in RAM or EEPROM. Writing to EEPROM depends on
the FB input signal.
Writes an instruction code and processes the instruction.
Specifies the CC-Link IE Field Network Basic station number and the parameter number and changes
the inverter parameter setting.
Obtains the whole 16-bit data of operating status of the inverter with the specified station number.
Monitors the whole data of output frequency of the inverter.
Indicates the fault record and the warning record of the inverter with the specified station number.
Specifies the CC-Link IE Field Network Basic channel number and the parameter number and reads
the inverter parameter setting.
FB used
• M+INVERTER-CC-IEF-Basic_Running
• M+INVERTER-CC-IEF-Basic_StopRunning
• M+INVERTER-CC-IEF-Basic_WriteFRQ_TRQ
• M+INVERTER-CC-IEF-Basic_MonitorStatus
• M+INVERTER-CC-IEF-Basic_MonitorFRQ
• M+INVERTER-CC-IEF-Basic_SetParameter
• M+INVERTER-CC-IEF-Basic_ReadParameter
• M+INVERTER-CC-IEF-Basic_ExecuteCommandCode
• M+INVERTER-CC-IEF-Basic_ResetError
• M+INVERTER-CC-IEF-Basic_MonitorAlarm
Reference
Page 36 Example Programs
Page 48 Changing and checking
the parameter
Page 49 Switching the operation
mode
Page 50 Resetting an inverter error