Table of Contents
Advertisement
3.
4.
Turn the wing panel over and delect the
aileron in the opposite direction from the
opposite side. Apply thin C/A glue to each
hinge, making sure that the C/A penetrates
into both the aileron and wing panel.
Using C/A remover/debonder and a paper
towel, remove any excess C/A glue that may
have accumulated on the wing or in the
aileron hinge area.
Repeat this process with the other wing
panel, securely hinging the aileron in
place
.
Ater both ailerons are securely hinged,
irmly grasp the wing panel and aileron to
make sure the hinges are securely glued
and cannot be pulled out. Do this by
carefully applying medium pressure, try-
ing to separate the aileron from the wing
panel. Use caution not to crush the wing
structure.
Hinge
Epoxy
5.
Note :
Work the aileron up and down sev-
eral times to "work in" the hinges
and check for proper movement.
WING TIP BULBS
Please see below pictures.
1.
hey are designed to operate on volt-
ages 12 volts.
2.
5
Advertisement
Table of Contents
