Table of Contents
Advertisement
NOTE: Installation of the tailBeacon must be in accordance with AC
43.13-2B, Chapter 1.
7.4.3 Unit Installation
The tailBeacon unit must be electrically connected, then installed into the
Mounting Plate by aligning the mounting tabs on the tailBeacon with the
cut-outs in the Mounting Plate. This requires you to rotate the unit 45deg
from vertical before inserting. Once inserted fully, rotate Clockwise to
vertical and secure with M2 anti-rotation screws.
1. Prepare the aircraft wiring for connection.
2. Connect the red wire to the switched position light power wire using
environmental splices or equivalent. Environmental splices require
heating after install to activate the sealant.
UAV-1002185-001
Rev D
28
Advertisement
Table of Contents
