uAvionix tailBeacon TSO User And Installation Manual page 25

1. Remove the existing aft position light.
2. Detach the power wire(s) and protect them from damage
3. Ensure the thru-hole in the tail cone is at least 29mm in diameter and
allows straight passage of the tailBeacon main body.
4. Peel the backing from the Mounting Gasket and affix to the Mounting
Plate.
5. Install the Mounting Plate, in the appropriate orientation for your
aircraft, using either the supplied #4 or #6 hardware, or as defined
below.
a. If the included hardware does not match the thread type of your
aircraft, it is acceptable to use the hardware compatible with the
thread types required, only if when installed, the screw heads
do not protrude from the surface of the mounting plate as
shown below.
Note: Installation of the tailBeacon must be in accordance with AC 43.13-
2B, Chapter 1.
UAV-1002185-001
Rev D
25