uAvionix tailBeacon TSO User And Installation Manual page 27

add/replace thread locking compound on the screws, we recommend using
®
Vibra-Tite VC-3.
1. Remove the existing aft position light and mount.
2. Detach the power wire(s) and protect them from damage.
3. Ensure the thru-hole in the tail cone is at least 29mm in diameter and
allows straight passage of the tailBeacon main body with adapter in
place.
4. Install the Ercoupe Adapter into the tail cone and secure with two #6-
32 cap head screws, utilizing included 7/64" Hex driver.
5. Peel the backing from the Mounting Gasket and affix to the Mounting
Plate.
6. Install the Mounting Plate, in the appropriate orientation for your
aircraft, using the two supplied #4 screws. Ensure there is thread
locking compound applied to the #4 screws when installing the
mounting ring onto the adapter.
UAV-1002185-001
Rev D
27