Element Manager - Nortel Succession 1000 Installation And Configuration Manual

Element Manager

Internet Explorer browser configuration for Element Manager
Logging in to Element Manager
Element Manager can be used to configure IP Telephony parameters on the
system. It is accessed by pointing a web browser (Internet Explorer 6.026 or
higher) to the ELAN, TLAN, or node IP address of the Succession Signaling
Server.
Before and after you make a change to the customer database, perform a data
dump. The customer database is not impacted in this chapter. However, the
IP Telephony node is, and its files are backed up at the same time as the
customer database. Use the EDD command in LD 43, or use Element
Manager, (see "Backing up IP Telephony node configuration files" on
page 85).
For more information about Element Manager, refer to Succession 1000
Element Manager: Installation and Configuration (553-3001-232) and
Succession 1000 Element Manager: System Administration (553-3001-332).
Element Manager requires Microsoft Internet Explorer 6.026 or higher.
Element Manager is not supported on the Netscape browser.
Internet Explorer caching interferes with the Element Manager application,
such that users cannot see real-time changes as they occur. For this reason,
Internet Explorer caching must be turned off.
Before logging in to Element Manager, obtain the IP address of:
• the Succession Call Server (at a location other than a Branch Office), or
• the H.323 WAN Gateway (at a Branch Office)
Use the following credentials when logging on in to Element Manager:
• User ID =
admin1
• Password =
0000
IP Telephony node configuration
or any LAPW
Signaling Server
Page 83 of 116
Installation and Configuration