R
9.
10. Click OK → OK to accept the settings.
11. Connect the DVI monitor or the VGA monitor with DVI-to-VGA adapter to the board,
12. Turn on the ML50x board's main power switch and press the SYSACE RESET button.
13. Extract the associated training lab files to your local computer.
www.BDTIC.com/XILINX
ML505/ML506/ML507 Getting Started Tutorial
UG348 (v3.0.2) October 9, 2008
For Character delay, enter 20.
if available.
After the FPGA has been programmed, the LEDs in the lower left corner should be:
♦
Bus Error 1 and 2 = off
♦
FPGA INIT = green
♦
FPGA DONE = green
♦
System ACE "Err" = off
♦
System ACE "Stat" = green
Note:
When the CF card is ejected or not installed, the System ACE "Err" LED blinks.
Unzip the training lab files to a working directory, name the directory, and make note
of the directory's name. This directory with the extracted files is referred to as
<LAB_DIR> in this tutorial.
www.xilinx.com
UG348_05_040408
Figure 5: ASCII Setup
Board Setup
[Ref 3]
13