Second line of display
You can select what other information should be shown
on the second line of the display (see chapter "Settings
in the INFO menu"):
l/min
Flow rate
kWh
Energy consumption *
m³
Water volume *
Time
Time **
* You can set the values of these consumption displays
to zero.
** The clock has to be reset after a power interruption.
4. Operation
4.1
Operation and displays on the appliance
Temperature display
Bar graph showing output
Second display
for example time
Memory buttons 1 and 2
Info and ECO button
ECO display
Rotary selector for temperature
selection
Display range for:
"Wellness"
"ECO" mode
"Second line"
Display area for additional information; notify your contractor if these symbols are shown.
"Error"; see chapter "Customer service mode"
"Service"; see chapter "Customer service mode"
4.1.1 Setting the temperature
Operation
4.1.2 Allocating memory buttons
"Automatic water volume control"
"Childproofing"
"Clock"
»
Temperature selection 30 ... 60 °C, infinitely adjust-
able.
»
Required temperature 30... 60 °C to be saved
should be selected.
»
Hold down button 1 or 2 for three seconds.
Anti-scalding protection
Your qualified contractor can set a permanent tempera-
ture limit (see chapter "Customer service mode") to pre-
vent any water being drawn from the appliance at tem-
peratures that could lead to a risk of injury.
Air detection
The appliance is equipped with an air detector that largely
prevents damage to the heating system. If, during opera-
tion, air is drawn into the instantaneous water heater, the
appliance shuts down for one minute, thereby protecting
the heating system.
Display field for additional information:
Service, error
Backlighting
Display range for:
Wellness, automatic water volume con-
trol, ECO,
childproofing, second display, clock
"Orientation light"
Display indication
For example 43 °C.
OFF = heating is switched off.
For example 38 °C.
For example 38 °C and 43 °C.
Display flashes briefly once; temperature is saved.
Operation
25