Dmx Output (Optional) - Harvia sentiotec home.com4 Instructions For Installation And Use Manual

Installation instructions, only for experts

5.13. DMX output (optional)

1. Guide the DMX connection cables for the heater sensor through the cable
gland 7 into the low-voltage connection area.
2. Connect the DMS connection cables in accordance with the designations
on terminal strip f.
- DMX A (DATA +)
- DMX B (DATA -)
- GND (ground/shield)
Four different DMX protocols are supported, which are output at the same time
on the DMX output:
1. 8-bit RGBW
2. 16-bit RGBW
3. 8-bit hue value saturation (such as for COLLAXX coloured light devices)
4. 8-bit hue saturation value
Use the following address overview to integrate your coloured light unit into
the sauna control unit.
RGBW_8BIT
● Start address: Channel 1
► Channel light group 1:
► Channel light group 2:
► Channel light group 3:
► Channel light group 4:
RGBW_16BIT
● Start address: Channel 17
► Channel light group 1:
► Channel light group 2:
► Channel light group 3:
► Channel light group 4:
1
5
9
13
17
25
33
41
p. 25/64
EN