Activating Standby For Remote Operation; Switching Off Functions; Switching Off The Sauna Control Unit - Harvia sentiotec Pro C2 Instructions For Installation And Use Manual

Instructions for use for the user

10.11. Activating standby for remote operation

EN 60335-2-53 specifies that sauna control units with a remote start function
must be set manually to "Standby for remote operation" mode. This activation
must take place again after each remote start and stop procedure. To do so,
perform the following steps:
1. Turn the function selector 2 to position I (remote start).
► "oFF" appears in the intensity display 4.
2. Press the bottom knob to activate "Standby for remote operation" mode.
► "on" appears in the intensity display 4 and the remote start symbol
starts flashing.
► The sauna control unit is then ready to be started and stopped using
a remote start signal.
► After a remote start and stop, the remote start symbol goes out and the
mode has to be activated again.

10.12. Switching off functions

You can switch off each function individually.
1. Turn the function selector 2 to the function you want to switch off.
► The intensity selector 3 lights up.
2. Press the intensity selector 3.
► This respective device is switched off.
► The light on the intensity selector 3 goes out.

10.13. Switching off the sauna control unit

● Press the ON/OFF switch 6, to switch off the sauna control unit.
► The lights go out on the function selector 2, on the intensity selector
and on the intensity level indicator.
► The sauna control unit is switched off.
p. 39/48
EN