Table of Contents
Advertisement
DOK-MOTOR*-MKE*GEN2***-PR06-EN-P
Rexroth MKE Synchronous Motors for Potentially Explosive Areas acc. to ATEX and UL/CSA
13
Commissioning, Operation and Maintenance
13.1
Commissioning
Preparation
Bulk head connector
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Commissioning in ATEX atmospheres is prohibited until it has been ascer‐
tained that the overall system corresponds to the demands and certification
conditions for ATEX protection.
The motors must only be operated with Rexroth drive control devices. Control
devices from other manufacturers are not permitted.
CAUTION
Do not perform a commissioning, if ...
●
the connections, operating states or product data are unclear or faulty.
●
the safety equipment and monitoring of the system is damaged or not in
operation.
Never use any damaged products.
Contact Rexroth for missing information or support during commissioning.
1.
Keep the documentation of all products you are using ready.
2.
Check the products for damage.
3.
Check all mechanical and electrical connections (incl. the potential
equalization line!).
4.
Log all measures taken in the commissioning log.
5.
Activate the safety and monitoring equipment of the system.
When all requirements are met, proceed as follows:
1. Carry out the commissioning of the drive system according to the in‐
structions of the corresponding product documentation. You can find the
respective information in the functional description of the drive control
devices.
2. Log all measures taken in the commissioning report.
The commissioning of drive control devices and the control unit may require
additional steps. The inspection of the functioning and performance of the
systems is not object of these operating instructions; instead, it is carried out
within the framework of the commissioning of the machine as a whole. Ob‐
serve the instructions and regulations given by the machine manufacturer.
Bosch Rexroth AG
Commissioning, Operation and Maintenance
Damage to property due to errors in the con‐
trols of motors and moving elements! Unclear
operating states and product data!
119/135
Advertisement
Table of Contents
