Wifi Setting - Wansview NCB521W User Manual

http://www.wansview.com

5.1.2 WIFI Setting

WIFI setting page, as shown in Figure 18, the wireless network list will be listed in search
of wireless networks. Select one of the network, and then check "Enable" in the list below
the relevant parameters of the selected wireless network will be filled out automatically,
enter the key then click Save to complete the wireless network setting.
Note1: When the device is connected both WIFI and wired, it will firstly connect to the
wired network, if it can't connect to it, then it will change to connect to the wifi. The
IP address and port is the same, either wireless or wired network.
Note2: Before you do the configuration of wireless as shown above; please make sure
the device is connected to the network via network cable. After settings succeed,
please unplug the cable and reboot the device, and then wireless function takes
effect.
Figure 17 Basic network
Figure 18 WIFI settings
15