Advanced Setting; Wifi Setting; User Settings - Wansview W1 User Manual

Save Picture to Email: When an alarm is detected, the camera will send two alarm pictures to the email you set. We support Gmail,
Hotmail, Yahoo, Gmx etc.
Save Picture to FTP: When an alarm is detected, the camera will send 2 alarm pictures to the FTP server you set, 3-4 pictures will
be sent if the motion is too frequent.
Save Record to FTP: When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length is
about 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.
Save Picture to SD/TF: When an alarm is detected, the camera will send 2 alarm pictures to SD card, 3-4 pictures will be sent if
the motion is too frequent.
Save Record to SD/TF: When an alarm is detected, the camera will send alarm video to the FTP server you set. The video length is
about 15 seconds for each alarm video, for constant recording, the alarm will be upload to FTP every 30seconds.
Trigger IO Output:When an alarm is detected, the external IO output device will be linked then send alarm; it doesn't support PoE.
Preset Linkage: When an alarm is detected, it will be linked to the camera to Pan/Tilt the camera to the Preset you set.
Speaker Linkage:Link the speaker to send alarm when a alarm is detected.

3.4.4 Advanced Setting

3.4.4.1 WiFi Setting

3.4.4.2 User Settings

Support Email/ Skype: service2@wansview.com
Click to enter "Advanced Settings", user can edit camera's advanced
settings.
Tap【WiFi Setting】 , User can manually set
WiFi.
Note:
1. It only accept 2.4GHz WiFi signal.
2. The password shall be not longer than 31
characters. The following special characters
are not be supportted in SSID and
password: ' and &
18