Unboxing - Filament Innovations BFP-ICARUS-TYPHOON Manual

Unboxing

The BFP-ICARUS 3D Printer ships in a wooden crate, weighing between 500
- 550 lbs. The crate dimensions are as follows:
ICARUS-X Crate Size:
Using the tools and instructions listed below, you should be able to easily
remove your ICARUS from the palette and remove the shrink wrap. The
unboxing process will require two people.
Required Tools Not Included for Unboxing
• Powered Drill with a #2 Philips bit
• Crowbar or Hammer
• Basic metric Allen key set
• 19 mm or adjustable wrench
Steps for Unboxing
1. To remove the outside panels, use a crowbar or hammer to remove the
staples around the outside of the box.
2. Once the panels are removed, use a hammer or crowbar to remove
the wooden frame around the printer.
3. Once the crate is open, locate the metal L-brackets securing the
printer to the pallet. Remove the pallet side of the bracket using a drill
and the printer side using a number 4 Allen key
4. Use the 19 mm wrench to raise the stabilizer feet so the wheels are
touching the floor of the crate.
5. You and another person can now remove the printer from the crate by
carefully rolling it off. The printer should still be in the shrink wrap at this
time.
6. Move the printer approximately where it will be operated and remove
all the shrink wrap from the machine. After the shrink wrap is removed,
move the printer into its final position. As a reminder, the filament
chamber is on the right side of the machine and needs an additional
27 inches to open properly.
52 x 40 x 76 (in)
6