Filament Innovations BFP-ICARUS-TYPHOON Manual page 13

Steps for Turning on your ICARUS
1. Use the supplied 110 VAC power cord to plug the printer into a wall
outlet. The unit should be on a minimum 15 amp breaker; however, we
suggest a 20 amp breaker.
2. Ensure that the emergency stop is disengaged - turn clockwise to
disengage the button.
3. Flip the red toggle switch to turn on the printer. At this point the screen,
water chiller, and the cooling fans on the control box should turn on.
You may also turn on the LED's using the blue toggle switch.
Steps for Turning off your ICARUS
1. Press the System Cool Down button on the home screen to turn off the
heated bed and hotend.
2. Wait for the red Heated Bed and Hotend indicator lights to turn off.
3. Flip the red toggle switch down to power the unit off.
Troubleshooting the Power
The BFP-ICARUS is a straight forward machine to power on and off,
however there may be times when troubleshooting may occur.
• 20amp Breaker – A breaker is located inside the control box, on the
bottom right. If the unit does not turn on, there may have been a
power surge on the electrical line the printer is plugged into. Please
check to see if the breaker has a green(off) or red (on) color on it. If
it is green, please flip the breaker to power the unit back on
• Emergency Stop – Is the emergency stop pressed in? This will cut
power immediately to the unit. Turn this clockwise to disengage it.
• Power Plug – Please check that the plug is fully inserted into the
control case on the back of the machine.
13