Filament Innovations BFP-ICARUS-TYPHOON Manual page 23

3. Unplug the bulkhead connector on the back of the heatcore
assembly be squeezing the plastic tabs down, on each end of
the connector.
4. With the new heatcore assembly in hand, reverse steps 3 and 2.
Plug the bulkhead connector into the new heatcore and turn the
thumbwheel clockwise to tighten it to the extruder.
5. CRITICAL – Run the Z-Offset tuning macro to re-calibrate your Z-
Offset and enter the new value into the config.g file.
23