Changing Heatcores (Nozzles) - Filament Innovations BFP-ICARUS-TYPHOON Manual

Changing Heatcores (Nozzles)

The Typhoon extruder comes with quick swap heatcore (nozzle)
assemblies. One of the benefits of this system is how easy it is to swap
heatcores.
Please be sure the filament is removed from the Typhoon before going
any farther and the heater temperature is below 100C to prevent burning
of your hands.
1. Move the Typhoon to a place where it is easy to handle and
lower the bed (Z Axis) 50mm.
2. Locate the thumb wheel and turn it counterclockwise until the
entire heatcore separates from the extruder.
22