Table of Contents
Advertisement
WiFi Connectivity
The Duet2 WiFi board comes with built in WiFi connectivity for 2.4 GHz
networks (it will not work on 5 GHz networks). Since initial connectivity tests
are performed before the unit is shipped, all that needs to be done is to
type in your SSISD and Password for your WiFi network. If you have the
version that utilizes a CAT5/6 connection, please
directly to Step 8.
Steps to Directly Connect your Printer to WiFi
1. Press the Console button on the touchscreen.
4. Enter the following command to temporarily disable the built-in WiFi
card:
M552 S0
5. Enter your wireless network's name and password exactly as shown
below by using the on-board keyboard feature. Be sure to enter your
own network name and password where you see NetworkName and
Password – the quotation marks must stay. This command is case
sensitive. Press enter to send the command.
M587 S"NetworkName" P"Password"
Example: M587 S"FilamentInnovations" P"3dprinter"
In the event that your network name and/or password are too long to
display on the screen, there is a USB cable included inside the Duet Wifi
box you can use to enter the Wifi settings from your computer. Open
the control case and look for the mini-HDMI port located on the bottom
left of the board. You will need the Machine Control panel in Simplify3D
to communicate with the board. If you are doing this from a computer,
the machine should be powered off at this time. This is covered in detail
here:
Advanced Wifi Setup
3. Next, type the following command to have the printer try to connect to
the internet. Press enter to send the command.
M552 S1
visit this link here
and go
25
Advertisement
Table of Contents
