Table of Contents
Advertisement
4. After about thirty seconds, you will see a message on the LCD screen
indicating whether or not the WiFi connection was successful. If it was
successful, you will see a message like the following:
WiFi module is connected to access point NetworkName, IP address
192.168.1.239
5. Log onto a computer and ensure it is connected to the same WiFi
network as the printer. Type the IP address of your printer (the number
similar to 192.168.1.239) into an internet browser from a PC, laptop, or
the included Microsoft Surface.
6. From your web browser, you will see Duet Web Control and be able to
send gCode files to your printer for wireless printing.
7. If you received an error message, try typing the network name and
password again, and be sure you are not trying to connect to a 5 GHz
network. Additional support can be found in Helpful Links and
Resources.
NOTE – If your Duet Wifi board suddenly cannot connect to your
network, then it is likely your router assigned a new IP address to it. From
the Duet Screen, go to the Console, type in M552, press the enter key,
and in a few seconds the new IP address will be listed on the screen.
Connecting the Wyze Webcam to the WiFi Network
Every ICARUS comes equipped with a Wyze Webcam that is IP/internet
enabled (2.4 GHz network only). Download the Wyze application to your
phone to check in on your printer remotely, anywhere you are.
The Wyze setup process is done via the instructions that can be found in
the box or on the smartphone app. Your camera is only powered on
when the printer is powered on.
26
Advertisement
Table of Contents
