Pickup Assembly - Canon Paper Deck Unit-F1 Service Manual

Pickup Assembly

■ Actions at Replacement
"Removing the Pickup Assembly" on page 42
■ Actions after Replacement
● Pre-Separation Plate Adjustment
1. Remove all sheets of paper from the Compartment and close the Compartment.
2. Turn ON the main power.
3. ( When the imageRUNNER ADVANCE C4500 series connected.)Execute the following item on the service mode.
• (Lv.1) COPIER> FUNCTION> CST> DK1-INT1( Initialization at Deck parts replacement)
4. Execute the following item on the service mode. Stop at pickup position
• (Lv.1) COPIER> FUNCTION> CST> DK1-SPAD(Setting of Deck Lifter stop position)
<Setting value>
0 to 1
0:Stop at lower limit position
1:Stop at pickup position
NOTE:
Even DK1-SPAD is set to 1, the value is returned to 0 when the Compartment is opened.
5. Check that the position between the Pre-Separation Plate and the Lifter Plate is same. Adjust it on the following
procedure in case that it is not same.
[2]
[1]
64
5. Adjustment