Installation Of The Lifter Wire - Canon Paper Deck Unit-F1 Service Manual

5. Remove the Lifter Wire[1].
[1]

Installation of the Lifter Wire

■ Rear
1. Put the Lifter Wires through the right and the left
lifter holes on the Lifter Plate.
• Long Lifter Wire: Put it through the left hole on the
plate.
• Short Lifter Wire: Put it through the right hole on the
plate.
NOTE:
Red dot is marked on the Long Lifter Wire.
2. Put the Long Lifter Wire[2] through the Small
Pulley[1] and then fix it on top left part of the
Compartment[3].
• 1 Screw[4]
1x
53
4. Disassembly/Assembly
[1]
[4]
[2]
[3]