Installing The Spindles - Gaggenau CG 492 Installation Manual

Installing the Spindles

cover plates
20
• Loosen both cover plates, slide to the center and
remove.
• The gas taps of the burners must be in the off
position (flat side to the top). Slide the spindles
(hollow section) on the square profile on the back
of the control knobs. Firmly slide the coupling
onto the stud on the taps.
• Fix the spindles with the screws provided.
• Replace and screw on both cover plates.
Spindle extensions (SV 405-022 / SV 405-032) are
available should the appliance be installed in a
worktop which is non-standard depth.
• Pull the spindles horizontally from the control
knobs (the spindles are tightly fitted).
• Insert the longer spindles from behind into the
fittings of the control knobs. Be careful that the
broader pin of the control knob fits the broader
fitting of the spindle.
• Continue the installation as described above for
the standard spindles.