Installing The Cooker - Gaggenau CG 492 Installation Manual

Installing the Cooker

❷
❶
• Before installation, remove all styrofoam
packaging from the control knobs and peel off
the protective film.
• Hold the support plate from the rear against the
cabinet front (make sure the angled edge of the
support plate is on the bottom), insert control
knobs into the holes, secure from the rear with the
nuts. Take care to install control knobs in the
correct order.
Please note: if you want to convert the appliance
to a different type of gas, change the nozzles
before installing the appliance (see user manual).
• Insert the supporting frame into the cut-out and
align it centrally. Secure the appliance with the
clamping screws included.
• Place the decorative frame onto the supporting
frame. Be careful to align the decorative frame
level with the worktop. If necessary, adjust the
clamping screws.
For alignment you can take off the decorative
frame and use the metal adjusting piece included
(thickness 1 mm). Slide the adjusting piece along
the frame and make sure the adjusting piece is
level with the worktop.
• Stick the sealing tape along the marker points
onto the rear part of the decorative frame.
• Detach the sealing strip at the back of the
appliance: loosen 3 screws and take off the
sealing strip forward
• Undo trough securing nuts and carefully detach
the trough.
• Horizontally insert the trough into the supporting
frame and align. Screw the trough onto the
supporting frame at the 4 marked points.
❶ ❷
and then up .
19