Preparing The Cabinet - Gaggenau CG 492 Installation Manual

Preparing the Cabinet

min. 700
Important notes concerning the cabinet
The gas cooker is suitable for flush mounting into a
worktop. For technical reasons, the top of the pot
grids will be approx. 2 mm above the worktop
surface.
The gas hob can be fitted into the following types of
heat and water-resistant work surfaces:
- Stone work surfaces
- Work surfaces made of plastic or Corian
- Stainless steel work surfaces (welded)
- Solid wood work surfaces, following consultation
with the manufacturer of the work surface (sealing
edges of cut-out)
Installation in other types of work surface
(e.g. chipboard) is not possible.
1007
+1/-0
983
604
+1/-0
580
R9
90∞
Worktop depth min. 70 cm.
The unit into which the hob is built must be heat
resistant up to 90 °C.
Do not install the cooktop lower than the work
surface.
All cut-outs in the worktop are to be carried out at a
specialist workshop. The cut must be clean and
precise, since the cut edge is visible on the
surface.
The stability of the furniture being worked on must
also be ensured following the cut-outs.
Clean and degrease the edge of the cut-out, using
a suitable cleaner (follow the instructions given by
the silicone manufacturer).
7
±0,5
12
17