Installing The Appliance - Gaggenau VG 231 CA Operating And Assembly Instructions Manual

8.4 Installing the appliance

Fig. 18
Fig. 19
Fig. 20
5080004026ind02 en 10.04 EB
– Produce the recess for one or several Vario
appliance(s) in your worktop. Proceed as
indicated on the installation sketch and the
dimension table. The dimension table contains
details of the space requirement for the trim
between the appliances.
Important: the angle between the cut surface
and the worktop must amount to 90° (Fig. 18).
– Mark the centre of the recess exactly. Secure
the securing rails on the front and rear edges of
the recess. Make sure that the lugs of the securing
rails lie on the worktop and that the centre
marking of the securing rails is precisely flush
with the centre marking on the worktop (Fig. 19).
Secure the cover on the appliance before
installation. See assembly instructions
VD 201-010.
– Lower the appliance into the worktop. Make
sure that the engaging lugs on the appliance lie
exactly on the clamping springs. Press the
appliance firmly into the worktop. The engaging
lugs on the appliance "snap" into the clamping
springs (Fig. 20).
Note: When installing the appliance in granite or
marble worktops, have the holes produced by a
specialist or stick on the securing rails with a
temperature-resistant 2-component adhesive (metal
on stone).
Note:
Several appliances can also be installed in
individual recesses, as long as a minimum
clearance of 40 mm (1
the appliances.
9 / ") is kept to between
16
21