Graco Renegade Series Operation - Repair - Parts page 36

Repair
4. Ensure new o-rings are installed in
diverter block and remain in place.
Position diverter block on the manifold.
Align the three screws in the diverter
block with the corresponding holes in the
manifold. Secure with the three M6
screws. Torque to 6-8 ft-lbs (8.1-10.8
.
N•m)
5. Reattach coil on to valve. Tighten plastic
nut finger-tight to top of valve.
36
6. Position the 4-way valve on the diverter
block, it will only fit in one position.
Secure with the four M6 screws. Torque
to 6-8 ft-lbs (8.1-10.8 N•m).
7. Remove and dispose of plastic cover
over the plug on the terminal of new
valve.
8. Attach wire harness into terminal on
4-way valve, secure by tightening the
retaining screw.
3A6884B