Jumpers; Jumper Description; Jumper List - Advantech RSB-3430 User Manual

2.1

Jumpers

2.1.1

Jumper Description

Cards can be configured by setting jumpers. A jumper is a metal bridge used to close
an electric circuit. It consists of two metal pins and a small metal clip (often protected
by a plastic cover) that slides over the pins to connect them. To close a jumper, you
con- nect the pins with the clip. To open a jumper, you remove the clip. Sometimes a
jumper will have three pins, labeled 1,2 and 3. In this case you would connect either
pins 1 and 2 or 2 and 3.
The jumper settings are schematically depicted in this manual as follows.
A pair of needle-nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes.
Generally, you simply need a standard cable to make most connections.
2.1.2

Jumper List

Table 2.1: Jumper List
LVDS_VDD_SLT
LVDS_BKLT_SLT
SW
RSB-3430 User Manual
LVDS Power
Backlight Power
Boot device
6