4 door 6th gen bronco off-grid floor system (12 pages)
Summary of Contents for JCROffroad JLRK
Page 1
• 80/20 Slide-in T-Nut (4) • 18-8 SS Button Head 1/4-20 SS (4) Please read the mounting instructions below Thank you for purchasing your new roof rack from JcrOffroad! Checkout our website, www.jcroffroad.com for other great off- carefully before attempting to install.
Page 2
Assemble the rack on the ground. It’s easier to assemble the rack first then install it as one piece on the Jeep. Be sure to orient the crossbars with the milled t-slot holes facing up. This will allow you to add t-nut hardware for mounting gear later. Bolt the crossbars to the side rails using the 3/4"...
Page 3
Bolt the fairings on the rack, using the same 3/4" button head bolts and washers as the crossbars, with the addition of flange nuts on the inside (3 per side for the front fairing, 2 per side for the rear). For now, position the fairings up as high as they will go and snug the bolts. We will adjust them down once the rack is on the roof.
Page 4
With the help of a friend, place the rack up on the Jeep with the mounts sitting in the drip rails. Position the rack from front to back on the roof. A good rule of thumb is to place the rear fairing at the seam in the back of the hardtop.
Page 5
Adjust the rack up and down at each mount to level the rack. Then tighten up all of the mounting brackets. Adjust the fairings down firmly against the roof. This will prevent them from flexing at higher speeds. Make sure all of your hardware is tightened and enjoy your new roof rack!