Advertisement
Quick Links
6TH GE N BRON CO
OV E R HE AD
MO LLE PAN EL
IN S TAL L I NSTRU C TIO NS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
Thank you for purchasing from JcrOffroad! Checkout our website, www.jcroffroad.com for other great off-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don't hesitate to call us at 269-353-1184!
Advertisement
Related Manuals for JCROffroad MOLLE
Summary of Contents for JCROffroad MOLLE
- Page 1 Be sure to check out the install video on the product page, if available. Thank you for purchasing from JcrOffroad! Checkout our website, www.jcroffroad.com for other great off-road products. Be sure to rate and review our product online. If you have any questions or are missing parts, please...
-
Page 2: I Nclu D E D Hardware
I NCLU D E D HARDWARE 1/4"-20 X 3/4" 1/4"-20 Button Head . Flange Nut... -
Page 3: Included Parts
I NCLU D E D PARTS 1L/1R... - Page 4 AS SE M BLY Before starting the installation, you will need to some disassembly in your vehicle. Start by removing the sun visor catches which are held in place by one bolt in the inside of each. This requires a T20 torx bit. Next, gently but firmly apply downward pressure on the top of the overhead console in order to pull it out of its clips (circled below).
- Page 5 AS SE M BLY For the overhead console to be able to snap back into place later, you will need to trim roughly 1/4” from the top edge of the plastic. Simply cut a straight line across, just above the bend radius as shown below. With everything out of the way, you will be able to see the bolts holding the roof latches in place.
- Page 6 AS SE M BLY Next, loosely install the side mounting brackets. The hooked side of each slides into the slots in the top of the roll bar just behind the front seats. It can then be bolted into the factory threaded hole that lines up with the hole in the bracket using the hardware that is already there.
- Page 7 AS SE M BLY Once everything is in place, mount the MOLLE panel to the bottom of the cross bar and front mounting bracket using the same 1/4”-20 hardware. The narrower end of the panel is the front, and the sides should be pointing up.