Table of Contents
Advertisement
Using a Barcode Scanner to Scan Patient ID and/or Operator Information
1. Main menu
Start a test by tapping
Make sure that RFID card is
placed on the Analyser.
4. Input menu
Scan patient information with the
barcode
scanner.
automatically be set as "ID" value.
Tap
to confirm the input or
to exit to the main menu.
How to Wake-Up the My Care Insite or Switch it OFF
When the Touch Screen displays the main menu, the "power safe" function dims the screen.
Pressing the Lock Switch will re-illuminate the display. It is not necessary to switch the Analyser
off every day. Switching the Analyser off completely can only be done by disconnecting it from
the power supply.
PI MCI-EUR Rev 02
2.Test screen
The MyCare Insite displays the
.
type of test and number of tests
remaining on the RFID card.
Tap
to proceed to the input
menu or
menu.
5. Insert test cartridge and close door
The door opens automatically.
It
will
Insert the test cartridge (Cuvette
with Sample Collector) and close
the door. The test procedure
starts automatically.
to exit to the main
3. Select operator screen*
On this screen an operator can
now be selected by scanning the
operator barcode and tapping
to continue.
If new information is scanned (i.e.
the operator has not been created
in the operator menu yet) a new
operator
will
be
automatically.
This screen only appears when
*
operator input is enabled (page 20).
created
23 / 46
Advertisement
Table of Contents
