Table of Contents
Advertisement
Indicator lights
MyCare Insite Analyser front
How to Handle the MyCare Insite Analyser Laboratory Photometer
The Analyser is operated solely by means of the Touch Screen. All the basic operating steps are
displayed as symbols in Table 1 (page 2), and
Manual (page 3).
To activate a symbol tap it with a finger.
In order to perform a test, the RFID card enclosed in the test kit must first be placed on the analyser.
This card contains all the data needed to perform the tests. No analysis can be started without the RFID
test card.
The door opens automatically when a test is initiated by pressing the
the requested data on the Touch Screen and inserting the test cartridge (Cuvette closed with Sample
Collector) into the Chamber, close the door. The test starts automatically. After the test is completed,
the door opens automatically and the test cartridge is removed.
The door prevents ambient light, dust, dirt and humidity from entering the Analyser during the testing
process, and when the Analyser is not in use.
Please make sure the door is closed whenever the Analyser is not in use.
How the MyCare Insite Analyser Laboratory Photometer Works
The MyCare Insite Analyser laboratory photometer is a measuring device. To perform a test, the
MyCare Insite Analyser is loaded with a test cartridge (Cuvette with Sample Collector containing a
sample). The Analyser automatically processes the test when the door is closed. The latest LED
PI MCI-EUR Rev 02
LEDs on the MyCare Insite Analyser
This green LED indicates the Analyser status
LEDs
This blue LED indicates Touch Screen connection status
This blue LED indicates Bluetooth connection status
Note:
the Touch Screen powered.
Flashing: the Analyser is warming up and testing cannot be
Note
started yet. (
: warm-up takes approximately 10 min.)
On (green): the Analyser is warmed up and ready for use
Off: the Analyser is not plugged in
On (blue): connection with Touch Screen is established
Off: the Touch Screen is not connected
On (blue): connection with Touch Screen is established
Flashing: Analyser Bluetooth is activated but no Touch Screen
is connected via Bluetooth
Off: Bluetooth is switched off
Use of the USB cable connection is recommended to keep
Table 2:
Abbreviations and Definitions in the User
button. After entering all
10 / 46
Advertisement
Table of Contents
