Advertisement
Mounting the Pump
Models 226013, 226018, and 244637
1. Mount the pump on pump support bracket (86).
2. Remove inductor plate nut (11 or 24), locking
ring (8 or 23) and O–ring (9). See Fig. 3.
3. In order, slide inductor plate nut (11 or 24), locking
ring (8 or 23) and O–ring (9) on pump riser tube.
4. Adjust the inductor plate on the pump so that the
pump intake is 0.12 in. (3.2 mm) above the
mounting base. Tighten the locknut (11 or 24)
securely. See Fig. 3 Detail. Continue with step 4
below.
NOTE: The full length of the pump intake slots must
be just below the bottom of the inductor cone as
shown in Fig. 3 Detail.
Model 204490
1. Lubricate the o-ring (20) in the inductor plate (18)
with light, waterproof grease. See Fig. 2.
2. Mount the pump on the pump support (64) so the
fluid outlet faces front. See Fig. 3.
3. Guide the pump intake valve as far as possible
into the inductor plate, then tighten the set-
screws (19). Continue with step 4 below.
All Models
4. Loosen the pump support clamps again and raise
the support (64) until it meets the pump base.
5. Secure the President or Fire-Ball pump to the
pump support mounting plates from the underside
with the screws.
6. Tighten screws (68) on lower pump bracket (83).
7. Slide the upper support bracket (83) up or down
(the tubing of the pump support [64] will flex
slightly) until the pump is in a true vertical position.
Tighten the screws (68) on the upper bracket.
18
Fig. 2
8
306556
Installation
20
19
0724
85
89
62
83
61
41
90
62
A
104,
103,
E
105
102
2, 18, or 22
DETAIL
8 or 23
2 or 22
INDUCTOR PLATE for
Models 226013, 226018, and 244637
Fig. 3
68
64
73
91 or 97
86
65
27
47
10
11 or 24
0722A
pump riser
tube
11 or 24
pump intake
slots
0.12" (3.2 mm)
0723
Advertisement
