Ikelite 6146.19 Manual page 11

4. Line up the Mounting Screw with the Camera Tripod Socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
1/4-20 Threaded Hole
1/4-20 Mounting
Screw
5. Pull out on the housing control knobs to move the controls out of
the way.
6. RAISE the camera flash if using a fiber optic strobe, otherwise,
leave the flash closed. NOTE: The flash CANNOT be opened once
the housing is closed.
7. Insert the Mounting Plate into the slot on the inside bottom of the
housing. Slowly push the camera all of the way forward until the
back of the Mounting Plate is flush with the Housing Plate Mount.
The flash will contact the top of the housing and rotate back 90
degrees so it faces up inside the housing. The flash should be lined
up with the housing's fiber optic ports once the camera is pushed all
the way forward and the housing is closed.
Camera Mounting Plate
Camera Tripod Socket
11