Installing An Accessory Via The Accessory Port - Ikelite 6146.19 Manual

5. Attach one end of the fiber optic cord into one of the fiber optic
ports on the front of the housing. The connector is a press-fit into
the fiber optic port.
6. Attach the other end of the fiber optic cord to a compatible strobe.
7. Set the strobe to the appropriate setting based on manufacturer
recommendations.
8. Turn the strobe on.
9. Take a test photo to ensure that your strobe is functioning properly.
10. Repeat steps 3-9 when connecting a second strobe.

Installing an Accessory via the Accessory Port

1. Remove the Hole Plug using an 11/16" open end wrench.
2. Check the accessory fitting o-ring sealing area. Check o-ring and
housing o-ring sealing area. All should be clean and free of hair,
sand, or other debris.
3. Lightly lubricate o-ring with Ikelite lubricant. Use ONLY Ikelite
lubricant. Other manufacturer lubricants can cause the o-ring to
swell.
Fiber Optic Connector
O-ring
PowerShot G1 X
Mark II
S
MF
S
DISP MENU
17