Activating The Base Unit; Basic Use, With Button - Barco ClickShare CSE-800 User Manual

Getting started

3.1 Activating the Base Unit

About power mode
You can power on and off the Base Unit and bring the system in standby mode. In standby mode the system
mutes the output signal to the displays. If your display supports this, it will automatically enter power saving
mode.
Power on the Base Unit or awake it from standby
1. When the Base Unit is shut down, set the rocker switch at the back of the Base Unit to "I".
1
Image 3–1 Power switch
2. If the system does not start up automatically, push the standby button shortly.
Image 3–2 Standby button
The system is now powered on.
Put the Base Unit in standby
1. Push the standby button shortly
To shut down the Base Unit
The Base Unit can be shut down in two ways :
1. Push the standby button until the Base Unit shuts down
2. Set the rocker switch at the back of the Base Unit to "0"

3.2 Basic Use, with Button

Basic functionality
When entering a meeting room equipped with ClickShare and if the display is not in screensaver mode, the
ClickShare wallpaper is shown on the display. The content of the wallpaper depends on the setup.
38 R5900050 /13 ClickShare CSE-800
Image 3–2.
Image
Image
3–2.
3–1.