Installation; Customer-Supplied External Battery; Required Tools - Eaton Powerware Series User Manual

Chapter 3

Customer-Supplied External Battery

Required Tools

Eaton ® BladeUPS ® External Battery Interconnect User's Guide

Installation

This section explains:
S
Customer-supplied external battery
S
Required tools
S
Choosing a mounting option
S
Attaching the mounting bracket
S
Attaching the External Battery Interconnect
S
Wiring the External Battery Interconnect
S
Connecting the External Battery Interconnect to the Eaton
BladeUPS 12i
When configuring a BladeUPS 12i module with external batteries, use
either Eaton-supplied EBMs only or customer-supplied external batteries
only. You cannot use a combination of EBMs and customer-supplied
external batteries with the same BladeUPS 12i module. See Table 5 on
page 30 for specifications related to customer-supplied external
batteries.
NOTE If using customer-supplied external batteries, configure the BladeUPS user setting
for Watts per cell. For information on customer-supplied external battery setup, refer to the
user's guide for the BladeUPS module.
The following tools are required for installing the External Battery
Interconnect:
S
Phillips #2 screwdriver
®
S
Wrench or sockets to accommodate M4 and M5 hex nuts
S
Torque driver for slotted screws, to accommodate settings of
47.5 ± 2.7 and 61.0 Nm (35 ± 2 and 45 lb in)
S
164201794 Rev 3 www.eaton.com/powerquality 15