Recovery Method Of Defective Nozzle Discharge - MIMAKI Tx300P-1800 Care And Maintenance

14. Recovery method of defective nozzle discharge

When this printer has not been used for an extended period of time, or depending on the environmental
temperature, the discharge at the nozzles could become unstable. In such a case, the following methods may be
taken to recover the status of the nozzles.

For symptoms 1 to 4 in P.14 "The examples of defective printing"
1. Daily maintenance and care

Perform the cleaning of the parts described in this document.
2. Performing Head Cleaning (normal). Refer to Chapter 2 of
Operation Manual.

After having performed the care and maintenance stated in step 1, perform
the cleaning of the heads in accordance with the procedures stated in
Operation Manual.
3. Performing Head Cleaning (hard). Refer to Chapter 2 of
Operation Manual.

If the nozzle missing does not disappear even after repeating the head
cleaning (normal) several times, reset the cleaning mode to "hard" and
perform the cleaning again.
4. Perform the cleaning of the head nozzles. Refer to Chapter
4 of Operation Manual.

Perform the cleaning of the head nozzles. In this case, leaving time of the
cleaning liquid for maintenance shall be made [1 minute].
5. Perform the cleaning of the head nozzles again. Refer to
Chapter 4 of Operation Manual

Reset the leaving time of the cleaning liquid for maintenance to [10
minutes], and perform the cleaning of the head nozzles again.
• If the nozzle discharge does not recover even after operating above, contact your local
15. Supplies
Product Name
Dye Sublimation Ink ink :Sb420
Dye Sublimation Ink ink :Sb421
Cleaning Liquid
(MAINTENANCE
KIT)
Clean stick for the surroundings of the head 50pcs
Techno wipe for the surroundings of the head
Rubber stopper for 2L case
*: Tx300P-1800 MkII only, when using the Sb411+TP400 or Sb411+Sb420 ink sets.
distributor, our sales office, or service center.
Disperse dye ink :Dd400
Acid-dye ink :Ac400
Reactive-dye ink :Rc400
Reactive-dye ink :Rc500
Hybrid : Sb411+Sb420
Textile Pigment ink: TP400
Hybrid : Sb420+TP400
Hybrid : Sb421+TP400
Hybrid : Sb411+TP400
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
Product No.
ML003-2-K1
C-ML012-Z-
K1-1-KW
SPC-0527
SPC-0855
SPA-0250
15
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Product Name
CP pat set（Cap Pad）
CAP ABSORBER KIT
Waste ink tank (2L)
Wiper kit 300TS
*
Wiper kit 300Tx-II
INK TRAY SPACER
300 fan filter
Pinch rollers
MEDIA HOLDER Tx
MALE CONNECTOR
ABSORBENT FOR MBIS
check
check
check
check
Product No.
SPA-0269
SPA-0314
SPA-0246
SPA-0271
*
SPA-0313
SPA-0276
SPC-0774
SPA-0275
SPA-0278
SPA-0625