Table of Contents
Advertisement
12. Replacing consumables
(1) Replace the blow down fan filter ("Replace the blow down fan filter" Chapter 4 of the
Operation Manual)
Replace the blow down fan filter (SPA-0774) when it is dirty.
(2) Replacing the wiper ("Replacing the wiper" Chapter 4 of the Operation Manual)
The wiper is consumable. When the display indicates the warning message "Replace a WIPER" it is necessary to
check and replace the wiper, immediately replace the wiper with a new one.
• The wiper will differ depending on the particular machine model and ink sets. Replace the wiper as
indicated in the following table.
• Be sure to use the correct wiper corresponding to the usage conditions. Using the incorrect wiper
may cause nozzle falling off.
Model
Tx300P-1800
Tx300P-1800 MkII
• When the warning message for replacing wiper is shown, confirm whether there is no damage and
fuzz at the top edge of the wiper film. If there is no damage on the top edge of the wiper film, it is
possible to use the wiper continuously without replacing it.
• A cleaning wiper is an option.Buy one through the dealer in your region or at our service office.
(3) Replacing the Cap Absorber ("Replacing the Cap Absorber" Chapter 4 of the Opera-
tion Manual)
CAP ABSORBER KIT (PN: SPA-0314) and CP PAD SET(PN:SPA-0314) are consumable. If the dirt is severe or
the ink falls off from the carriage, replace it.
Replace the CAP ABSORBER KIT (PN: SPA-0314) when the warning message "Replace Cap Pad" is displayed
on the local or guidance screen.
(4) Replacing the Pinch roller ("Replacing the Pinch roller" Chapter 4 of the Operation
Manual)
Replace the pinch roller (PN: SPA-0275) when it is worn or dirty.
• The pinch roller is an optional item. You can buy one through your local dealer or from our service
office.
• Since the parts are small, you need to take extra care not to drop them into the gaps in the machine.
(5) Replacing the Spout Rubber Assy ("Replacing the Spout Rubber Assy" Chapter 4 of
the Operation Manual)
Install the spout rubber in an eco case in order to reduce ink leakage from the 2L ink pack.
The spout rubber is a supplied part. (SPA-0250: Set of 8 Rubber stopper 2L for case)
The replacing timing sign of the spout rubber will be shown about once every half-year.
Please replace the spout rubber when you see the sign on the display.
Ink set
----
Other than the following
Sb411+TP400/Sb411+Sb420
Product No.
SPA-0271
SPA-0271
SPA-0313
12
Wiper
Product Name
Wiper kit 300TS
Wiper kit 300TS
Wiper kit 300Tx-II
Advertisement
Table of Contents
