Table of Contents
Advertisement
7. When replace the media
(1) Ink receiving spacer ("Cleaning the Ink receiving spacer" Chapter 4 of the Operation
Manual)
When you wish to clean dirt such as ink etc. adhered on the
ink receiving spacer, you can remove the ink receiving
spacer to clean it.
8. Daily care
• When possible, use the cleaning stick (SPC-0527) for cleaning around the head/ capping station/ wiper.
Using the other cotton bud may attach lint, then it may damage the machine.
• Be sure to perform maintenance for the ink cap and the wiper of capping station every day. If you leave it
dirty, dirt may adhere to the nozzle surface, or, dust and dry ink may be rubbed against the nozzle. It may
cause discharge defect.
• Clean the bottom of carriage every day so that it will not get dirt from inks or dusts. If you leave it dirty, dust
and dry ink may be rubbed against the nozzle at wiping operation when performing head cleaning.
• When you clean the carriage bottom surface, fully be careful not to rub the nozzle surface.
(1) Surroundings of the heads ("Cleaning the Head and the Area around It" Chapter 4 of
the Operation Manual)
• The heads and their surroundings are the parts most liable to be tainted in this machine and if
tainted, it could cause adverse effects to the functions of the machine and the results of the
printings. Moreover, as the head itself uses very fine mechanisms, sufficient precautions are
required for the care and maintenances.
• Use the cleaning liquid dedicated for the ink being used.
1
Move the carriage to the left and open the
maintenance cover.
• Refer to the Step 1 to 2 of Chapter 4 "Cleaning the
Head and the Area around It" of the user's manual to
perform the operation.
4
Advertisement
Table of Contents
