Recovery Method Of Defective Nozzle Discharge - MIMAKI JV300-130 Requests For Care And Maintenance

12. Recovery method of defective nozzle discharge

When this printer has not been used for an extended period of time, or depending on the environmental tem-
perature, the discharge at the nozzles could become unstable. In such a case, the following methods may be
taken to recover the status of the nozzles.
For symptoms 1 to 4 in P.14 "The examples of defective printing"
1. Daily maintenance and care

Perform the cleaning of the parts described in this document.
2. Performing Head Cleaning (normal). Refer to Chapter 2 of
Operation Manual.

After having performed the care and maintenance stated in step 1, perform
the cleaning of the heads in accordance with the procedures stated in
Operation Manual.
3. Performing Head Cleaning (hard). Refer to Chapter 2 of
Operation Manual.

If the nozzle missing does not disappear even after repeating the head
cleaning (normal) several times, reset the cleaning mode to "hard" and
perform the cleaning again.
4. Perform the cleaning of the head nozzles. Refer to Chapter
4 of Operation Manual.

Perform the cleaning of the head nozzles. In this case, leaving time of the
cleaning liquid for maintenance shall be made [1 minute].
5. Perform the cleaning of the head nozzles again. Refer to
Chapter 4 of Operation Manual

Reset the leaving time of the cleaning liquid for maintenance to [10
minutes], and perform the cleaning of the head nozzles again.
• If the nozzle clogging does not recover after the above operations, contact your local distributor, our
sales office, or service center.
13. Supplies
Product Name
Cleaning-Solution Bottle kit A29
Cleaning solution MS2/ES3/HS kit 200
Cleaning Stick for Head Surrounding (50 sticks)
Male Connector Absorbent for MBIS
MBIS Eco case ASSY
300 Fan Filter
Mist Catch Filter
3 Inches Paper Tube 130
3 Inches Paper Tube 160
Media Cutter Blade
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
In the event nozzle missing etc. have not been improved
Product No.
SPC-0137
SPC-0369
SPC-0527
SPC-0625
SPC-0626
SPC-0774
SPC-0810
SPC-0825
SPC-0826
SPA-0107
15
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Perform test printing and
(Chapter 2 of Operation Manual)
Product Name
Wiper kit 33S
Kimwipe S-200
Wiper cleaner
Square waste ink tank 2L
Pinch roller
Exhaust BOX
Exhaust BOX filter
Rubber stopper for 2L case
CP pad set 2
check
check
check
check
Product No.
SPA-0134
SPA-0207
SPA-0243
SPA-0246
SPA-0247
SPA-0248
SPA-0249
SPA-0250
SPA-0257