Yardworks 060-3890-8 Instruction Manual page 17

model no. 060-3890-8 | contact us: 1.866.523.5218
• Make sure your extension cord is
in good condition. When using an
extension cord, be sure to use one
heavy enough to carry the current your
product will draw. A wire gauge size
(A.W.G.) of at least 14 is recommended
for an extension cord 50' (15 m) or
less in length. If in doubt, use the next
heavier gauge. The smaller the gauge
number, the heavier the cord. An
undersized cord will cause a drop in line
voltage, resulting in loss of power and
overheating.
• Do not point the blower nozzle in the
direction of people or pets.
• Never place blower on any surface,
except a hard, clean surface, when
motor is running. Gravel, sand and
other debris can be picked up by the
air inlet and thrown at the operator or
bystanders, causing possible serious
injuries.
• Never run the unit without the proper
equipment attached. Always ensure the
blower tubes are installed.
• When not in use, blower should be
stored indoors in a dry, locked place—
out of the reach of children.
• Maintain tool with care. Keep fan area
clean for best and safest performance.
Follow instructions for proper
maintenance.
• Do not attempt to clear clogs from tool
without first unplugging it.
• Do not pull or carry by cord, use cord
as a handle, or pull cord around sharp
edges or corners. Keep cord away from
heated surfaces.
• Do not unplug by pulling on cord. To
unplug, grasp the plug, not the cord.
• To reduce the risk of electric shock, do
not expose to rain, do not use on wet
surfaces. Store indoors.
• If the power supply cord is damaged,
it must be replaced only by the
manufacturer or by an authorized
service centre to avoid risk.
• Protect your lungs. Wear a face or dust
mask if the operation is dusty. Following
this rule will reduce the risk of serious
personal injury.
• Save these instructions. Refer to them
frequently and use them to instruct
others who may use this power tool. If
you lend someone this power tool, lend
these instructions also.
17