Page 1
BRUSHLESS BLOWER WITH AERO FORCE TECHNOLOGY ® model no. 060-3095-2 | contact us: 1.866.523.5218 3026035 IMPORTANT: Instruction Read and follow all safety rules and operating Manual instructions before using this product.
Page 2
model no. 060-3095-2 | contact us: 1.866.523.5218 model no. 060-3095-2 | contact us: 1.866.523.5218...
Congratulations on your purchase of your new Yardworks tool. It has been designed, engineered ® and manufactured to give you the best possible dependability and performance. Should you experience any problem you cannot easily remedy, please contact our Yardworks ® customer service line at 1.866.523.5218.
model no. 060-3095-2 | contact us: 1.866.523.5218 FOR ALL APPLIANCES safety guard. Check the alignment of the moving parts, the binding of the moving • Avoid dangerous environments — do not parts. Check for broken or defective use appliances in damp or wet locations. parts that can affect the safe operation •...
Page 6
model no. 060-3095-2 | contact us: 1.866.523.5218 ejected from the battery; avoid contact. ADDITIONAL SAFETY WARNINGS If contact accidentally occurs, flush IMPORTANT SAFETY INSTRUCTIONS with water. If liquid contacts eyes, seek When using an electrical appliance, basic additional medical help. Liquid ejected precautions should always be followed, from the battery may cause irritation or including the following:...
Page 7
If contact has s) Recharge only with the charger been made, wash the affected area specified by Yardworks . Do not ® with copious amounts of water and use any charger other than that seek medical advice.
Page 8
model no. 060-3095-2 | contact us: 1.866.523.5218 model no. 060-3095-2 | contact us: 1.866.523.5218 Information for radiated emission This device complies with Canadian ICES- 001. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and...
Page 9
Do not burn. Yardworks CANADA has established a partnership with the ® RBRC Corporation to recycle any Yardworks batteries with the ® RBRC-call2recycle seal. For environmental protection, please do not discard batteries in the trash. After the battery’s life cycle is ended, please call 1-800-822-8837 for a free service that will properly dispose of the battery.
model no. 060-3095-2 | contact us: 1.866.523.5218 Turbo button On/off switch with variable speed control Handle Battery pack (not included) Motor housing Tube release button Aeroforce tube Battery pack release button (not included) We recommend that you purchase your accessories from the same store that sold you the tool.
model no. 060-3095-2 | contact us: 1.866.523.5218 NOTE: Before using the tool, read the instruction book carefully. ASSEMBLY 1. ASSEMBLING AND REMOVING THE BLOWER TUBE (SEE FIG. A1) - ASSEMBLING Before assembling the blower tube, be sure the on/off switch is in “O” Off position. Insert the blower tube directly to the motor housing as shown in Fig.
model no. 060-3095-2 | contact us: 1.866.523.5218 OPERATION BEFORE PUTTING INTO OPERATION 1. CHARGING THE BATTERY (SEE FIG. B) a. The battery pack (not included) must be fully charged before first use. b. If the battery pack is very hot you must remove your battery pack from the charger and allow your battery pack to cool first to ambient temperature and then recharging can be started.
Page 14
model no. 060-3095-2 | contact us: 1.866.523.5218 CHARGING INDICATOR This charger is designed to detect some problems that can arise with battery packs. Indicator lights indicate problems (see table below). Light ON/ Flash Status Defective Battery Red on Battery Temperature Protection. The temperature of battery pack is less than 0 C (32...
Page 15
model no. 060-3095-2 | contact us: 1.866.523.5218 3. STARTING AND STOPPING (SEE FIG. D) - STARTING Move the on/off switch forward to the “I” position. - STOPPING Move the on/off switch backward to the “O” position. - VARIABLE SPEED CONTROL The on/off switch with variable speed (2) controls the airflow.
Page 16
model no. 060-3095-2 | contact us: 1.866.523.5218 4. USING THE BLOWER (SEE FIG. E1, E2) The blower is intended for residential use only. Use the blower outdoors to move debris from hard surfaces. Adjust the airflow by adjusting the on/off switch to use in different working conditions. USER TIPS - Hold the blower tube approximately 8”...
Page 17
model no. 060-3095-2 | contact us: 1.866.523.5218 5. TURBO BUTTON FOR POWER BOOSTING (SEE FIG. F) Turbo button can increase airflow significantly, and it can be used for clearing heavy or wet debris. To use the turbo button, first switch on the blower, push the on/off switch forward to select any speed control, then depress the turbo button and hold it.
model no. 060-3095-2 | contact us: 1.866.523.5218 Remove the battery pack before carrying out any adjustment, servicing or maintenance. There are no user-serviceable parts in your blower. Keep the motor ventilation slots clean. Keep all working controls free of dust. CLEANING THE TOOL Clean the tool regularly.
® Symptom Possible Causes Solution at 1.866.523.5218. The blower does not start Defective motor or on/off switch Contact Yardworks ® Relieve the load on the machine Overload and battery immediately and allow cooling for The blower suddenly stops temperature too high approx.
model no. 060-3095-2 | contact us: 1.866.523.5218 Item Description QTY. Left Decorative Cover Left Housing Right Housing Right Decorative Cover Button Set Compression Spring Cover Button Set Spring Rubber Trigger Slide Gear Linkage Switch Assembly Control Board Torsional Spring Rubber Ring Bracket Motor Baffle...
(365) days from the date of retail purchase. Made in China. Imported by Yardworks Canada Toronto, Canada M4S 2B8 Always remove or disconnect the battery pack before adjusting, cleaning, servicing or transporting your appliance.
Page 25
BRUSHLESS BLOWER WITH AERO FORCE TECHNOLOGY ® Item # 060-3095-2 | contact us: 1.866.523.5218 ASSEMBLY ASSEMBLING AND REMOVING THE BLOWER TUBE OPERATION 1. CHARGING THE BATTERY (not included) (SEE FIG. B) 2. REMOVING AND INSTALLING THE BATTERY PACK(not included) (SEE FIG. C1, C2) * This information is provided for your convenience.
Page 26
BRUSHLESS BLOWER WITH AERO FORCE TECHNOLOGY ® Item # 060-3095-2 | contact us: 1.866.523.5218 3. STARTING AND STOPPING (SEE FIG. D) 4. USING THE BLOWER (SEE FIG. E1, E2) 5. TURBO BUTTON (SEE FIG. F) To use turbo button, first switch on the blower and select a speed, then depress the turbo button and hold it.