Software Installation Information - Moxa Technologies NPort 5600-8-DT Quick Installation Manual

DIN Rail Mounting
DIN-rail attachments can be purchased separately to attach the product
to a DIN-rail. The DIN-rail attachments should be oriented with the
metal springs on top.
Standard Attachment
NOTE The operating temperature of the power adapter in the box is
from 0 to 40°C. If your application is out of this range, please
use a power adapter supplied by UL Listed External Power
Supply (The power output meets SELV and LPS and rated 12 -
48 VDC, minimum current 0.73 A). Moxa has power adapters
with wide temperature range (-40 to 75°C, -40 to 167°F), the
PWR-12150-(plug type)-SA-T series, for your reference.
Pull High/Low Resistors for RS-485
Use the set of DIP switches on the bottom panel to set the pull high/low
resistor values for each serial port. To access the switches, remove the
screws holding the DIP switch cover in place and flip open the cover.
There are three DIP switches for each port's pull high/low resistors:
Default 

Software Installation Information

For the NPort's configuration, the default IP address of the NPort
is:LAN: Static; IP = 192.168.127.254; netmask = 255.255.255.0
NOTE If you have forgotten the NPort's IP address, use the Device
Search Utility (DSU) from your PC to locate the NPort. After
searching the LAN for NPort units, the DSU will display the IP
address of each unit.
You may log in with the password moxa to change any setting to meet
your network topology (e.g., IP address) or serial device (e.g., serial
parameters). For first-time use, click the Wizard in the left navigation
SW
Pull High
ON 1KΩ
OFF 150KΩ
DK-35A Attachment
1
Pull Low
- 5 -
2
1KΩ
150KΩ
3
Terminator
120Ω
–