Doosan Power Train D50S-5 Specifications Systems Operation Testing & Adjusting Disassembly & Assembly page 50

12. Install the pressure plate at its place in the
cylinder.
13. Assemble the pressure plate at its place in the
cylinder, mount the snap ring (50) using a screw
driver.
14. Assemble 3 seal rings on the shaft.
Take care not to damage the seal ring in the
counter shaft.
15. Refer clauses 5 through 8 for the opposite side
of the shaft assembly.
16. Apply clean transmission oil on the clutch plates
and discs. Assemble clutch disc plates in
following procedures.
a. First, assemble the plate having teeth on outer
diameter.
b. Next, assemble the clutch disc having teeth on
inner diameter.
c. Repeat procedures (1) and (2) until all the
discs and plates are assembled.
d. Assemble the bending plate (67) with its
bended part downward.
Power Train
CAUTION
17. Install the pressure plate in the cylinder.
18. Assemble the snap ring(50) which sets the
pressure plate in the cylinder, using a screw
driver.
19. Assemble thrust washer and needle bearing on
the counter shaft of the high speed clutch.
20. Assemble gear (46), thrust washer (45). Adjust
bearing cone (44) using assembling jig.
Do not exert excessive force when assembling
gears.
Move the gear forward/backward in to the clutch
assembly, until the gear spline aligns with the
teeth of the disc.
49
CAUTION
Disassembly and Assembly