Preparation - Pro-face GP4000M Series Installation/Replacement Manual

Connect the power cord.
Check the performance
and start operation.
*1: This step is required if screen data is saved only in the GP unit, not in any other device.

3.2 Preparation

Requirements for
receiving screen data
from GP-37W2 *1
Requirements for
converting screen data
of GP-37W2 and
transferring to
GP-4301TM
*1: This step is required if screen data is saved only in the GP unit, not in any other device.
*2: The software version must be the same or higher than the version that you used when creating
screen data for the GP-37W2 unit.
We recommend you upgrade to the latest version, which is GP-PRO/PBIII for Windows
C-Package03 (SP2) Ver. 7.29. If the version of GP-PRO/PBIII for Windows C-Package03 that you
currently use is version 7.0, upgrade it on our website [Otasuke Pro!]
(http://www.pro-face.com/otasuke/download/update/)
*3: GPW-CB03 is compliant with GP-PRO/PBIII for Windows C-Package02 (SP2) Ver. 6.23 or later.
Also, to use it, you may need to Install the driver on our website [OtasukePro!]
PC in which GP-PRO/PB3 for Windows Ver. 4.0 or later is
installed (*2)
Transfer cable
(The following three types of cables are available.)
・ GPW-CB02 (D-sub 9-pin to the PC)
・ GPW-CB03 (USB to the PC *3)
・ GP430-CU02-M or GPW-SET (D-sub 25-pin to PC)
PC in which GP-Pro EX Ver.2.71 or later is installed.
A USB data-transfer cable
(The following three types of cables are available.)
・ A USB data-transfer cable (model: ZC9USCBMB1)
・ A commercial USB cable (USB Type A/mini B)
* Possible to send/receive a screen with a USB flash drive
or via Ethernet.
12/46
Start connection and check
the communication.