Festo FEC Compact Brief Description page 31

7. If you are using the FST software:
7.1. Create a new project and select the IPC FEC Com-
7.2. Open the I/O configuration and add an input
7.3. Add a program and then insert the following lines
7.4. Select the program from the project tree, compile
7.5. Switch the controller to RUN (the RUN LED must
Festo KBS-FEC FC30- 0206NH English
pact as the controller.
module and an output module, both with address
0.
of code:
IF
THEN LOAD
TO
it and then download the project to the controller.
If you are not using COM1 on your programming
PC, then you must first switch to the COM port
that you are using.
light up green). If you now apply a signal at the
input, the output with the same address must
switch to "1".
NOP
IW0
OW0
31