IBM Aptiva Hardware Handbook page 64

Table 9: Error codes, descriptions, and corrective actions (Continued)
Error Code Description
164 Memory Size Error
20X Memory Error
30X Keyboard Error
60X, 662 Diskette Drive Configuration
Error
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these errors continue after taking the actions listed, check your Services and Support Guide for information on
obtaining service.
54 Error codes, descriptions, and corrective actions
Here's what to do:
1. If you added memory after Rapid Resume turned the computer off, press
Enter while the error message is displayed to enter the Configuration/Setup
Utility. Choose Save Settings at the bottom of the Configuration/Setup Utility
main menu and press Enter. Then exit the Configuration/Setup Utility. You
will lose any data that you did not save before the computer turned off.
2. If you have removed memory from your computer, press Enter while the
error message is displayed to enter the Configuration/Setup Utility. Choose
System Summary View from the Configuration/Setup Utility main menu to
verify that the new memory size is correct. For instructions on using the
Configuration/Setup Utility, see page 61. If you have not removed memory
from your computer, check your Services and Support Guide for information
on obtaining service.
Make sure memory modules (SIMMs) are inserted correctly and completely. For
instructions on inserting SIMMs, see "Installing and removing memory
modules" on page 102.
1. Make sure the keyboard and mouse cables are correctly and securely
connected to the ports on the back of the system unit.
The keyboard port has this symbol next to it to help you:
The mouse port has this symbol next to it to help you:
2. Make sure that a keyboard key or a mouse button is not being held down.
If you removed a diskette drive, press Enter while the error message is
displayed to enter the Configuration/Setup Utility. Choose Devices and I/O Ports
from the Configuration/Setup Utility main menu and verify that the Diskette
Drive settings are correct. If the settings are not correct, change the settings.
For instructions on using the Configuration/Setup Utility, see page 61.