IBM Aptiva Hardware Handbook page 101

Installing and removing a drive in bay 1 (continued)
3.
Left bracket replacement
Insert the left bracket catches into the slots and
slide the bracket forward until it locks into place.
Align the screw holes and insert the screws
Left Bracket
Drive
Catch
4.
Drive cable connection
Connect all drive cables.
Power Cable
(Back View)
If you are adding a diskette or tape drive that attaches
to the Diskette connector, make sure the signal cable
you plug into the drive is attached to the Diskette
note:
connector on the system board. To identify the
Diskette connector, see "Identifying parts of the
system board" on page 100.
Installing and removing a drive in bay 1
Drive
Signal Cable
91