IBM Aptiva Hardware Handbook page 78

Table 10: Error codes, descriptions, and corrective actions (Continued)
Error Code Description
1780 Drive 1 (Hard Disk) Error
1781 Drive 2 (Hard Disk) Error
1782 Drive 3 (Hard Disk) Error
1783 Drive 4 (Hard Disk) Error
24XX Video Error
2462 Video Configuration Error
Notes:
1. An X shown as part of the error code in this table represents any number between 0 and 9.
2. If any of these errors continue after taking the actions listed, check your A Guide to HelpWare and All the Extras folder for
information on obtaining service.
66 Error codes, descriptions, and corrective actions
Here's what to do:
1. Make sure the cables to all drives are securely attached.
2. Press Enter while the error message is displayed to enter the Setup Utility.
Choose System Information from the Setup Utility Main Menu and verify that
the Processor Speed setting is correct. (Find the processor speed [in MHz] on
the label attached to the front of your system unit.) If the setting is not
correct, check your A Guide to HelpWare and All the Extras folder for
information on obtaining service.
3. Make sure the hard disk signal cable is attached to the correct connector on
the system board and the jumper settings on the hard disk are correct. For
information about drive connectors and settings in the desktop system unit,
see "Installing additional drives" on page 95. For information about drive
connectors and settings in the minitower system unit, see "Installing
additional drives" on page 116.
1. Make sure the monitor cables are correctly and securely connected to the
system unit.
2. If a video adapter card is installed, make sure it is installed correctly. For
instructions, see the documentation that came with the adapter card.
3. If the error continues, remove the video adapter card. If removing the card
corrects the error, replace the card with a new one.
1. Make sure the monitor cables are correctly and securely connected to the
system unit.
2. If you added or removed video memory, or if you installed a video adapter
card, press Enter while the error message is displayed to enter the Setup
Utility. Press the Esc key and then press Enter to save the new setting.
3. Press Enter while the error message is displayed to enter the Setup Utility.
Choose System Information and Video and Monitor from the Setup Utility
Main Menu to verify that the settings for the Video Controller, Video Memory,
and Monitor Horizontal Frequency options are correct in the Setup Utility. For
instructions on using the Setup Utility, see page 69.